DeadlyGirraffe DeadlyGirraffe

27-05-2021
Social Studies

contestada

Why are “input” and “output” good words to use when describing systems?

Respuesta :

sarahoke sarahoke

27-05-2021

It gives a direct relation that can be used

Answer Link

pipercaulder5565 pipercaulder5565

27-05-2021

Because it can explain everything, and how it correlates to the system.

Answer Link

Otras preguntas

most midwestern cities were established near

what word is to deprive a person of legal rights and protection

If a pea plant has a genotype SSTt, what are the possible genetic combinations that could be present in a single grain of pollen produced by the plant?

Give an algebraic example of the Transitive Property.

Which of the following was not a goal of the Crusades? (5 points) A. stopping the spread of Islam to Europe B. conquering land en route to the Holy Land C. mod

Which of the following causes the formation of surf on a breaking wave? Beach erosion Low wind speeds Deposition of sand on a beach Friction with the oc

knowing the points a(1, 6), b(−5, −2), c(−1, −5), and d(5, 3), and that segment ab is parallel to segment cd, what is the length of segment ab and segment cd co

¿Qué te gusta más, esquiar o nadar? A. A mí me gusta mucho. B. No me gusta ni esquiar ni nadar. C. A ti te gusta también. D. A mí también.

Subtract and simplify: (3x2 - 6x + 7) - (x2 - 6x + 4) 1. 2x power of 2 + 6x + 3 2. 4x power of 2 6x + 3 3. 2x power 2 + 6x + 11 4. 2x

In what quadrant does 320 degree belong?